Details
2 port kit provides temperature control of underfloor heating circuit using thermostatic blending valve with circulating pump. The heated floor area should not be greater than 40m2.
Set includes:
- 2 Port Chrome Manifold
- 22mm blending valve
- 15-50 circulating pump
- Flow and return temperature sensor and gauge
- 2 x air vents
- 2 x filling and drain points
- 2 x 1" 1/4 turn manifold isolating valves
- 50m of edge insulation
- 2m of pipe conduit
- 400 staples (to fix pipe to floor insulation)
- 200m x 16mm PE-RT barrier pipe ~enough for enough for 40m2 @ 200mm pipe centres or
- 30m2 @ 150mm pipe centres or
- 20m2 @ 100mm pipe centres
- brass pump and compression 22mm pipe unions
- Instructions
Please note for clarity not all the parts supplied with this kit are shown in photo.
Questions on PE-RT Underfloor Heating Kit 2 Port x 200m
Sort by
- From max at 17/04/2011 12:51
- From max at 17/04/2011 12:56
- on top of insulation and wet underfoor heating can i use a normal 50mm sand and cement screed? Can the heating system be run of an lpg boiler and solar? What is the power requirement of the circulating pump?
- The UFH system can be run off of an LPG boiler. The mimimum screed depth required is 65mm.
- Do you find this question helpful? Yes No
- From Nick at 31/07/2011 08:54
- Would I need 1 or 2 thermostats to be added to an order for this product?
- If you want to control it as 1 zone, you would have 1 stat.
You can control it with 2 x stats if you want to control 2 areas
differently, but then you would also need a Danfoss wiring centre. - Do you find this question helpful? Yes No
- From Alan at 09/08/2011 10:51
- Is this suitable for use with a combi-boiler with an integrated pump inside the boiler casing i.e. there is no way of taking a feed off the boiler to the UFH before the existing central heating pump (which is a Grunndfos Alpha).
- It can be used with a combi boiler. If you have rads and UFH you would zone the 2 sections with 2 x 2 port zone valves to seperate them.
- Do you find this question helpful? Yes No
- From Paul at 25/10/2011 21:53
- I want to install Underfloor heating in a new extension with two rooms. One room is 15m2 the other is only half that. The first room is a living room the second a utility room. I assume I will require a 2 Port 100m kit, but what else will I need to fully install this solution.
- You would need a 2 port 150m. If you wanted to have 2 x zones you would also need 2 x actuators, 1 x Danfoss wiring centre and 2 x PRT room stats. If 1 x zone you would only need 1 x PRT stat and 1 x Honeywell junction box.
- Do you find this question helpful? Yes No